Programmable Rotary Hollow Shaft Encoder HSEC-100
Programmable Quadrature Output Rotary Hollow Shaft Encoder HSEC-100
This unique hollow shaft encoder is fully programmable, has a programmable volume compensation curve as well as a temperature sensor input making it ideal to measure volume on gas or propane pumps eliminating the need for a Scamp Device.
Several output types are programmable:
a 5..90º displacement between two similar edges of two phased outputs generated by a common input. In other words, two square wave outputs (A and B) having the same number of pulses per revolution are in quadrature relation to each other - if A leads B by 90° for clockwise rotation and B leads A by 90º for counter-clockwise rotation. The pulse outputs indicate amount of shaft rotation, and the A / B phase difference indicates direction of rotation. This output type is compatible with any control device that accepts quadrature inputs.
a single square wave output (A) with the programmed pulses per revolution (factory default 100 pulses) regardless of which direction the shaft is rotating (also called single output).
a digital output that indicates the direction of rotation: the output (B) is high when rotating in one direction and low when rotating in the other direction. Output (A) provides a single square wave output (A) with the programmed pulses per revolution (factory default 100 pulses per revolution)
Minimum/Maximum Speed Indicator
a digital output (A) that turns "on" when the encoder exceeds a predetermined revolution per minute (RPM), and turns "off" when the RPM is less than the predetermined RPM value while output (B) turns on if the RPM is below the predetermined minimum and turns off if above the minimum RPM.
16 volume compensation points can be set
Output can be compensated with an optional temperature probe input.
|Device ID||Max RPM||Min/Max Flanks
This Ringdale encoder has significant static protection. Encoder circuitry and output transistors are protected from high voltage transients to at least 6 kV direct discharge and 25 kV air discharge to either the encoder housing or the supplied cable when connected.
If you have special requirements please ask for a quote. We design encoders to suit your application.